2007-2017年中国沙尘气溶胶的三维分布特征及输送过程

利用最新发布的CALIPSO产品，构建了2007-2017年中国沙尘气溶胶的三维分布，并结合HYSPLIT-4模式和再分析数据，探讨了沙尘的三维输送过程。结果表明：中国的沙尘排放源区主要是塔克拉玛干沙漠和巴丹吉林沙漠，沙尘气溶胶出现频率分别为60%和35%。塔克拉玛干沙漠排放的沙尘主要（50%~70%）停留在源地0~6 000 m高度，少部分向东输送至甘肃和内蒙古；巴丹吉林沙漠排放的沙尘则主要向东输送。中国沙尘排放量在春季最大，向东输送最强；夏季，东亚夏季风限制了沙尘向东输送；秋季，沙尘排放减弱，输送强度和夏季相当；沙尘排放量在冬季最小，输送最弱。夏季，沙尘在输送过程中可被抬升至高度5 000 m以上，春季次之，秋、冬季的沙尘主要在低层大气输送。沙尘在向东输送的过程中被抬升并和当地人为污染物混合变为污染性沙尘，华北地区污染性沙尘出现频率高达30%；输送到海洋的沙尘也会与洋面上（0~3 000 m高度）的海盐气溶胶混合，出现频率约为10%。     

Explicit stress–strain equations for modeling frictional materials

In this paper, a comprehensive study on simulating the shearing behavior of frictional materials is performed. A set of two explicit equations, describing the relationship among the shear stress ratio and the distortional strain and the volumetric strain, are formulated independently. The equations contain three stress parameters and three strain parameters and another parameter representing the nonuniformity of stress and strain during softening. All the parameters have clear physical significance and can be determined experimentally. It is demonstrated that the proposed equations have the capacity of simulating the complicated shearing behavior of many types of frictional materials including geomaterials. The proposed equations are used to simulate the stress–strain behavior for 27 frictional materials with 98 tests. These materials include soft and stiff clays in both reconstituted and structured states, silicon sands and calcareous sands, silts, compacted fill materials, volcanic soils, decomposed granite soils, cemented soils (both artificially and naturally cemented), partially saturated soils, ballast, rocks, reinforced soils, tire chips, sugar, wheat, and rapeseed. It has been demonstrated that the proposed explicit constitutive equations have the capacity to capture accurately the shearing behavior of frictional materials both qualitatively and quantitatively. A study on model parameters has been performed.     

敦煌-格尔木铁路沿线风动力环境特征

敦煌-格尔木铁路沿线地形复杂、起沙因素多变、沙源丰富，沙害问题日益严重。目前对其风沙活动规律还未有研究，不利于防沙工作的开展。为此，通过对自北向南的5个观测点（S1、S2、S3、S4、S5）风速和风向的观测、计算和分析，利用平均风速、起沙风况及输沙势对敦格铁路沿线的风动力环境特征进行研究。结果表明：S5、S4和S3的风况对铁路风沙灾害防治意义较大。S5年平均风速、起沙风频率和输沙势最大，春季风沙活动最为强烈，且风向单一、风力强劲，风沙运动方向基本与铁路垂直，沙粒易在铁路附近堆积。S4夏季风沙活动最为强烈；S3春季风沙活动最为强烈，且风向单一，S4和S3的风沙运动方向与铁路夹角小于90°，附近沙源广阔，铁路易受风沙侵蚀，阻碍交通运营。     

Dust supply from river floodplains: the case of the lower Huang He (Yellow River) recorded in a loess–palaeosol sequence from the Mangshan Plateau

The Mangshan Plateau is located on the south bank of the Huang He (Yellow River) just west of the city of Zhengzhou, well outside the Loess Plateau in central China. Mixing models of the grain‐size data indicate that the loess deposits are mixtures of three loess components. Comparison of the mixing model with existing models established for a series of loess–palaeosol sequences from the Loess Plateau indicates that the Mangshan loess has been supplied from a proximal dust source, the Huang He floodplain, during major dust outbreaks. The high accumulation rates, the composition of the loess components, and especially the high proportions of a sandy loess component support this. Owing to the exceptionally high accumulation rates, the Mangshan grain size, magnetic susceptibility and carbonate records provide a high‐resolution archive of environmental and climate change. Copyright © 2008 John Wiley & Sons, Ltd.     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Strain localization in sand: an overview of the experimental results obtained in Grenoble using stereophotogrammetry

Experimental results are presented from the extensive program of drained plane strain compression tests on sand carried out in Grenoble over the last two decades. Systematic analysis of photographs of the deforming specimen allowed for measuring deformations and determining strain fields throughout the test, that is: prior to, at, and after the onset of strain localization. The principles, details and accuracy of the procedure are described, as well as its suitability to properly depict the patterns of deformation. Findings concerning the occurrence and progression of strain localization are discussed. The issues of shear band orientation and thickness are addressed, as well as temporary and persistent complex localization patterns, and the volumetric behaviour inside a band after its formation. The influence of such variables as initial state of the sand (effective stress and relative density), specimen size and slenderness, as well as grain size, is discussed. Copyright © 2004 John Wiley & Sons, Ltd     

Photopolarimetric studies of comet Austin

Photopolarimetric observations of comet Austin with the IAU/IHW filter system were obtained on the 2.34 m Vainu Bappu Telescope (VBT) of the Indian Institute of Astrophysics, at Kavalur, India, during pre-perihelion phase on February 20,1990 and on the 1.2 m telescope of the Physical Research Laboratory at Gurusikhar, Mount Abu during postperihelion phase on May 2 and 4, 1990. The comet appeared bluer than a solar analog during post-perihelion phase on May 2 and 4. The percent polarization shows a sharp increase towards the red on May 2 and 4. The dominant sizes of the dust particles appear to lie in a narrow range of 0.1 to 0.5 Μm. Regarding the molecular band emission, CN and C₂ bands are quite strong; C₃ emission was also found to be strong though the observations on May 2 and 4 show significant variation as compared to C₂ emission. Molecular band polarization for CN, C₃, C₂ and H₂ O+ have been calculated. It has been found that emission polarization in CN, C₂ and C₃ is between 1–7% (phase angle between 107.4–109 degrees). For CN and C₂ the polarization values are close to the theoretically predicted values, but for C₃ the polarization value falls much below the theoretically predicted value. A similar result was found for comet Halley.